How it works
How to use Instafix
-
Step 1
Use an acetone-based solvent (i.e. nail polich remover) to clean
areas where Insta-Fix will be applied. Surfaces must be free of
rust, grease, dust, old glue, etc. Allow solvent to dry. Remove
remaining material with sandpaper if necessary. -
Step 2
Make sure the surfaces to be bonded fit together with no gaps,
if gaps exist refer to the filler instructions or step 4.
-
Step 3
Apply a small amount of Insta-Fix to one side of the repair;
press firmly together for about 30 seconds, let it set for
5 minutes. If there are gaps in the area use filler to repair,
see filler instructions. Most repairs can be used in minutes after
they are finished. The tighter you press together the stronger the bond will be.